Feeding on the leaves appears to be one of the easiest ways to increase yield, growth speed and quality in a well ventilated, with or without elevated CO2 levels. Just prepare a tea of worm castings, fish emulsion, guano bats, or most other plant food right to work and feed in the vegetation and the early stages of flowering.
It is not recommended for late flowering, or that you should eat the sprayed materials later. leaf feeding off 2-3 weeks before harvest. Wash the leaves with water directly each week to prevent clogging the stomata of the leaves. Feed daily or every other day.
The best times of day to Foliar feed for the pots is 7-10 am and after 5 pm. This is because the stomata on the underside of the leaves are open then. The highest temperature is about 72 degrees and over 80, they can not be open to all. So find the cooler part of the day if it is hot, and hotter the day if it’s cold outside. You may need to be sprayed at 02:00 if that’s the coolest time available. The sprayer must spray the solution to a very fine mist, find your best sprayer and use it for this
Make pH 7 and 6.2. Use baking soda to make the solution higher PH, and vinegar to lower the pH of the solution. It ‘better to spray more often and spend less than the prescribed dose with the plants infrequently. Use a wetting agent prevents water from beads, and then burn the leaves as they act as small prisms. Make sure you do not spray a hot bulb, better yet, spray only when the lamp to cool.
Perhaps the best foliar feeding includes using seltzer water and plant food at the same time. This way, CO2 and nutrients are feed directly on leaves in the same jet. Foliar fertilization is recognized in most literature as a good way to get nutrients to the plant problems later when the lockout nutrients could begin to reduce the contribution of roots.
Buy Pot seeds from Amsterdam for high quality germination and growing purposes. Pot seeds from Amsterdam are world’s leading quality seeds with affordable prices.